LED stage lighting maintenance

First, the normality of the stage lighting directly affects the effect of the show! Therefore, the stage lighting equipment must not only do the maintenance and maintenance work, but also pay attention to some details in the work process, so there are so many postures, let me know about it!
Note for digital silicon box: When the machine is connected to the lamp, the main power supply should be cut off, and it is forbidden to pull and connect with the power. The machine should be placed in a ventilated place and protected from rain and lightning. If there is any abnormality, the power should be cut off immediately and repaired by a professional.


Second, the DMX computer light console notes: First, avoid plugging and unplugging the communication cable, otherwise the computer light will not be controlled by the console. Do not drink alcohol on the console of the computer light. The console of the computer light is a precision electronic device. Please pay attention to moisture and dust.


Third, the moving head lamp Note: Before each time you want to turn off the moving head light, first check whether the light bulb of the moving head light is off. If the light bulb has been extinguished, the heat can be turned off before turning off the power of the moving head light, otherwise it will affect the life of the light bulb or Damage to the lamp. Note: Do not modify the total number of channels of a computer light, otherwise it will affect the DMX first address code of the computer light behind it, resulting in the computer light is not controlled and can not be used normally. Do not wipe the lamp housing and coated filter with an organic solvent such as alcohol to avoid damage.






Fourth, the use of three primary colors Note: When replacing the lamp, you should wear a gauze glove, hold the middle part of the lamp with your fingers, first align the side of the lamp with the metal card point, and then align the other side. Relax, you can, the conductive card points on the lamp holder will cause contact failure due to oxidation due to long-term use. It should be wiped regularly. If the oxidation is serious, the contacts should be replaced in time. When the surface area of the reflector is cleaned, do not wipe it with a hand or a dirty cloth. Use a clean soft cloth or lens paper to ensure good light efficiency.